Calibration procedures

1 post • Page 1 of 1

derpmann: Posts: 460; Joined: Tue Apr 24, 2007 5:32 am; Location: Volkswagen AG, Wolfsburg - Germany

Calibration procedures

Quote

Post by derpmann » Thu Feb 19, 2015 11:58 am

Humanetics is developing the calibration procedures for 2D IR-TRACCs.
In autumn 2014 an intensive discussion with the users and software developers started.
This process is supported by the MME TaskForce.

The proposal for the ISO/TC22/SC36/WG3 ballot is:

ISO DTS 21476.pdf: Proposal for the WG3 ballot (not officially released by ISO!); (1.07 MiB) Downloaded 454 times

In this subforum the following drafts are available:

Attachments

2D IR-TRACC Verification Instructions Absolute Length 24April15.pdf: updated 2D IR-TRACC Calibration Instructions Absolute Lenght; (1.16 MiB) Downloaded 650 times

Section for WorldSID manual 2DIRTRACC draft 24MARCH15.pdf: Section for WorldSID manual 2DIRTRACC updated draft; (870.96 KiB) Downloaded 559 times

Section for WorldSID manual 2DIRTRACC draft 17DEC14.pdf: Section for WorldSID manual 2DIRTRACC draft; (843.27 KiB) Downloaded 563 times

IR-TRACC Calibration Instructions_Tubes in-out-draft 15december14.pdf: IR-TRACC Calibration Instructions Tubes in-out; (567.48 KiB) Downloaded 589 times

2D IR-TRACC Calibration Instructions Absolute Lenght-15December14.pdf: 2D IR-TRACC Calibration Instructions Absolute Lenght; (1.04 MiB) Downloaded 638 times

Post Reply

1 post • Page 1 of 1

Return to “IR-TRACC discussion”