we have seen in the wild some channels for the chest/abdomen deflection that have been coded in a special way.
So there are channels for the angle measurements, that occur twice with different naming:
- WS_Angle-ANZ.png (27.51 KiB) Viewed 4036 times
(the column "Langname" will show the code with the rib number associated)
For the WorldSID thoracic ribs this will end in three channels with the same coding
for the thorax ribs:
- Thorax_WS_triple_Angle.png (11.27 KiB) Viewed 4036 times
For the abdomen there will be two rib angles with the same name:
- Abdomen_WS_double_Angle.png (9.06 KiB) Viewed 4036 times
Based on the THOR/T3 channels provided from Crash Designer the intention for the naming seems to be:
original code -> linear
like : 11CHSTLEUPT3ANZP
-> .Transfer function used : Linear regression
03 -> Linear with offset:
like: 11CHSTLE03T3ANZP
-> .Transfer function used : Linear regression with offset
Also here you will get double named channels for the 4 thorax channels!
I guess this is not what is intended by the coding given for the THOR:
The coding for the angle is intended for the linear with offset channel or better to say for the
"absolute angle". There has been no 03 variant (cubic polynom) defined.
It would be helpful if we can disuss this together with Kistler, to avoid the confusion
for the users and implement a change in the generation of these channels.
May this is only a configuration problem at the users?
Kind regards,
Dirk
(@Paul: Am I limited to 3 attachments per message?)